Flat Rotary Surface Cleaners for Pressure Washers   Leave a comment


Flat Rotary Surface Cleaners for pressure washers.

Units, pricing and specs click here..

Pressure Washer Surface Cleaners

How To Deep Clean Large Flat Surfaces?

The solution is our flat surface cleaners

Pressure washer surface cleaners are powerful and reliable. They are used for high pressure cleaning driveways, concrete floors, parking lots, roofs, warehouses, boat ramps, garage floors, boat decks, and more. The benefits of using these products are clear: effective, shorter working times, enormous energy savings and long useful life due to their high industrial quality. You will be able to complete your power washing tasks in the shortest possible amount of time.

HOW DO SURFACE CLEANERS WORK?

High speed flat surface cleaners can consist of 2 or 3 (dual or tri arm) arms that spin in a counter clock wise direction for up to 1800 RPM (rotations per minute). At the end of each arm you will find a 1/4” MEG 25° spray nozzle that can cover the path from 16” to 30” diameter, depending on the size of the actual round housing. These cleaners can remove dirt for up to 15 times faster then the standard wands and 10 times faster than the water brooms. Operation: the user walks behind the unit holding the two handles from which one of them has a spray gun that works the same like any other pressure washer gun. The arms are connected to the shaft that is part of the spinning head (a mechanism that allows smooth rotation of the arm). These arms rotate/spin with the flow of the water (greater the water volume – the faster the spinning times), which creates a scrubbing action with the water coming out. The spray nozzles are only 1/2” to 2” away from the surface which allows greater cleaning capabilities. The edge of the housing and the brush skirt protect the surrounding area from over spraying. Some of our models come with the casters and some without. Units without the casters are designed to “hover” or “float” above the ground, so the maneuverability is not an issue. The greatest advantage of these machines is that they eliminate the “zebra” stripping usually found on driveways and sidewalks.

Some of the many uses for this pressure washer surface cleaner include:

Tennis Courts

Shuffleboard Courts

Basketball Courts

Roofs – Excellent Results with Clay Tile Roofs (Use Low Pressure on Shingle Roofs)

Pool Decks

Sidewalks

Driveways

Loading Docks

Warehouse Floors

Refrigerated Semi Trailer Floors

Operating Instructions of a Surface Cleaner

1) Connect to Pressure Washer.

2) Turn water on and open valve. Open trigger gun for flow of water through nozzles. Nozzles must have flowing spray. If not, remove tips and clean; reassemble, making sure that groove of nozzle is parallel to spray bar. Use Teflon tape when installing nozzles.

3) Start Pressure Washer. The flat surface cleaner is ready for operation.

4) Walk slowly behind the flat surface cleaner, cleaning as you go. If striping occurs, slow down your pace.

5) Periodically check weep hole on bottom of swivel. Water will seep slowly; if water shoots out, stop and replace seals. Swivel assembly can be rebuilt.

6) For maximum effectiveness keep spray nozzles clean. If the machine vibrates, stop and clean spray tips.

7) Lubricate swivel with one squirt of good quality grease every 200 hours of operation or about once a month if used daily. A small amount of grease coming out of the bottom of the swivel is normal.

DO NOT ALLOW MACHINE TO REMAIN STATIONARY ON SOFT SURFACES, SUCH AS WOOD.

CAUTION: Striking any raised obstacle during operation will damage machine. If contact does occur and results in vibration when operating machine, STOP and replace spray bar. Continued operation could result in serious injury or damage to machine.

What are the Benefits of the Flat Surface Cleaner

How much time will this equipment actually save me (versus using the standard wand)?

The following comparison shows the time taken to clean a typical size driveway (400 sq. ft.) using 2 different components.

Flat Surface Cleaner – 10 minutes

Standard wand – 80 minutes
Is there any over spray?

The brush skirt will eliminate any over spray.

Is it easy to move and control?

The unit is easy to move around. (units equipped with casters turn 360 degrees)

How close does it get to walls?

With the surface cleaner, you’ve got full wall clearance.

Does it save water or does it use more?  How much?

It uses the same amount produced by your pressure washer.

You state that it has “enormous energy savings”, how so?

You just walk behind it, v.s. if you clean with the standard wand you have to swing the wand 200-300 times to clean a typical size driveway.

Does it have a lot of maintenance/upkeep?

It has a minimum moving parts therefore very few possibilities that something will break down.

Units, pricing and specs click here..

Equipment Trade Service Co. Inc.has been providing Industrial Pressure Washer Cleaning Machinery, Chemicals and Supplies to Government, Transportation, Manufacturing, Construction, Contractors and Home Owners.
Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: